1Assistant Professor, Department of Mechanical Engineering, GATES Institute of Technology, Gooty, Andhra Pradesh India
2Principal & Professor, Department of Mechanical Engineering, GATES Institute of Technology, Gooty, Andhra Pradesh, India
There is a need for materials of high hardness and resistance to cutting. As we know the machining of these materials has always been a great challenge. Machining of these alloys and materials required for cutting high-strength, which sometimes is not economical and sometimes even impractical. And even the non-conventional processes are generally limited to the point of view of productivity. The advantages of easy component manufacturing of excessive hard materials can be substantial in terms of reducing costs and lead times machined compared to the traditional one involves the heat treatment, grinding and manual finishing/polishing. In the hot working at a temperature of work piece is increased so as to reduce its shear strength. This paper will focus on hot working and analysis of High Manganese Steel with petroleum fuel. Several parameters, such as cutting speed, feed, depth of cut and the temperature of the work piece are taken. An experiment was conducted. Even the machining process was simulated in ANSYS to find corresponding deformation, rate of tool wear, cutting force and the temperature distribution.
Cutting speed, feed, depth of cut and hot machining, non-conventional processes, FEM, tool wear, turning operation
