Design and fabrication of water pumping system using wind mill

In our project wind energy is used to rotate the wind blades. This blade coupled to the shaft. At the end of shaft the flywheel is placed. The eccentric arrangement is provided in the flywheel. When the blade rotates automatically flywheel also rotates. Due to the eccentric arrangement the rotation motion of the flywheel is converted into linear motion. This reciprocating motion is given to the handle of the pumping system. The up down motion of the handle is given to the piston, where the water is sucked using pressure variation from lower ground. Finally the water is supplied to the outlet. Wind blade provides the continuous motion which helps to supply the water continuously. Since time immemorial, the main source of energy has been coal, oil, natural gas, nuclear energy, wood and coal. However, all these sources are limited and are the main cause of pollution and this has led to development and more focus on sustainable energy supply with minimum pollution effects. Hence research and analysis has shown that wind energy, solar energy and biomass are the most prominent solutions to the above problems because they are eco-friendly and readily available in nature.