1Assistant Professor, Department of Civil Engineering, Mangalayatan University, Beswan, Aligarh, Uttar Pradesh, India
2Research Scholar, Department of Chemistry, Mangalayatan University, Beswan, Aligarh, Uttar Pradesh, India
3Assistant Professor, Department of Civil Engineering, KIET, Murad Nagar, Ghaziabad, Uttar Pradesh, India
4Associate Professor Department of Geology, Aligarh Muslim University, Aligarh, Uttar Pradesh, India
5Remote Sensing Application Center, Sector-G, Jankipuram, Kursi Road, Lucknow, Uttar Pradesh, India
*Corresponding Author: Harit Priyadarshi, Assistant Professor, Mangalayatan University, Beswan, Aligarh, Uttar Pradesh-202145, India, Email: gsiharit@rediffmail.com
Online published on 4 June, 2019.
Water is a chemical union between hydrogen and Oxygen. Water is unique in the sense that it can exist in three phases at almost the same temperature: Solid state (ice), liquid and gas (water vapour). On the earth, about 2/3 of the surface is covered by water and about 1/3 by land. So, water is a basic, natural resources for agriculture and industry. The present study was conducted to analyze the physico-chemical properties of groundwater from ten locations in Aligarh and Agra district of Uttar Pradesh. The samples were analyzed for seven water quality parameters in post monsoon season during the year 2017. The study area has a mean of pH 7.65, Total alkalinity 1002.2 mg/l, Electrical Conductivity 2.57 μS/m, Total Dissolved Solids 650.4 ppm, COD 94.2 mg/l, BOD 0.89 mg/l, and Fluoride 0.85 ppm. The results obtained from chemical analysis were compared with standard namely Bureau of Indian standards (BIS). From the analysis it has been observed that the drinking water quality in the study area is reasonably not good and it does show any alarming level of pollutants, however it needs some degree of treatment before use for drinking and other purposes. It also needs to be protected from the industrial waste and sewage contamination.
Water, Physico-chemical properties, Groundwater Quality, Pollutants
