International Journal of Applied Engineering Research, Dindigul

Table of Contents

• RESEARCH ARTICLE

  Current control strategy for BLDC drive in satellite ground station

  • Author: K. Sujaya, R. Heera Singh, B.C.S. Rao, M. Sathyanarayana

• Interlaminar failure analysis of FRP crossply laminate with elliptical cutout

  • Author: S. Venkateswara Rao, Sd. Abdul Kalam, S. Srilakshmi, V. Bala Krishna Murthy

• An experimental study on the effect of increased pressure on MIG welding arc

  • Author: K. Abbasi, S. Alam, M.I. Khan

• Shunt versus Series compensation in the improvement of Power system performance

  • Author: Irinjila Kranti Kiran, A. Jaya Laxmi

• Modeling, Optimization and Simulation of input parameters for optimum specific fuel (energy) consumption of LDO fired Rotary furnace

  • Author: R.K. Jain

• FPGA implementation of a fuzzy logic based handoff controller for microcellular mobile networks

  • Author: Dayal C. Sati, Pardeep Kumar, Yogesh Misra

• Implementation of Radio Technique in Interstellar Radiation Field for Locating Distant Stars

  • Author: A.B. Bhattacharya, D.K. Tripathi, A. Sarkar, A. Bhoumick

• Studies on Water Hammer Forming on Sheet Metal Works

  • Author: D. Lingaraju, Ch. Ramesh Babu, K. Ramji

• Manufacture of softplywood and hardplywood from Acacia Nilotica Plant extract and powder of agricultural waste or wood

  • Author: A.G Gaddamwar, P.R Rajput, S.C. Jirapure

• REVIEW ARTICLE

  A review on the design of MIMO antennas for upcoming 4G communications

  • Author: K. Jagadeesh Babu, K. Sri Rama Krishna, L. Pratap Reddy

• RESEARCH ARTICLE

  Design considerations of arrays as a viewing instrument of radio telescopes

  • Author: A. B. Bhattacharya, B. Raha, T. Das, M. Debnath

• Experimental and Numerical comparison between the performance of Helical cone coils and ordinary helical coils used as dehumidifier for humidification dehumidification in desalination units

  • Author: M.M. Abo Elazm, A.M. Ragheb, A.F. Elsafty, M.A. Teamah

• REVIEW ARTICLE

  Modeling and simulation of continuous Catalytic Regeneration (CCR) Process

  • Author: Majid Sa'Idi, Navid Mostoufi, Rahmat Sotudeh-Gharebagh

• Development of software to transform graphically the stress at a point inside a cube in three dimensional directions

  • Author: Md. Rashadul Islam, M.R.K. Bhuyan

• RESEARCH ARTICLE

  Conductivity study of PEO complexed with Mg 2+ borate glass polymer electrolyte – its application as electrochemical cell

  • Author: M. Jaipal Reddy, CH. Ramesh, J. Siva Kumar, U.V. Subba Rao

• REVIEW ARTICLE

  Effect on tensile strength of composite with reduced quantity of binder at elevated process temperature: A study on Mosquito Repellant coil (Composite) with elevated process temperature of Guar Gum (binder)

  • Author: Rabi Shankar Mukherjee

• RESEARCH ARTICLE

  Application of statistical techniques in market research: A sample survey

  • Author: Pratiksha Saxena

• A survey of literature of conceptual frameworks assessing supply chain flexibility

  • Author: Doordarshi Singh, Jaspreet Singh Oberoi, Inderpreet Singh Ahuja

• CASE STUDY

  Enterprise Resource Planning (ERP) of Canteen using USA Principle: A case study

  • Author: V. S. Gadakh, M. B. Mawale

• REVIEW ARTICLE

  A novel approach to energy efficient fault tolerant time synchronization protocols for wireless sensor networks

  • Author: Gopal Chand Gautam, T.P. Sharma

• Performance of copper coated two stroke spark ignition engine with Gasohol with Catalytic converter with different catalysts

  • Author: S. Narasimha Kumar, M.V.S. Murali Krishna, P.V.K. Murthy, D.N. Reddy, K Kishor

• TQM for manufacturing excellence: Factors critical to success

  • Author: Nitin Singla, Dinesh Khanduja, Tejinder Paul Singh

• Current-Mode PWM generator based on Active Inductor

  • Author: Saberkari Alireza, Panahdar Mohammadreza, Niaraki Rahebeh

• Flow Shop Scheduling using Simulated Annealing: A Review

  • Author: N Hooda, A. K Dhingra

• Numerical analysis of a corrugated metal pipe: A case study

  • Author: Md Rashadul Islam, M. A. Almasud

• Study on important factors of quay walls deformation under seismic loading

  • Author: Hesam Sharifian, Khosro Bargi, Mohamad Ahangar, Morteza Safarnezhad

• Studies on Hardness of Polymer HybridSilica/NRHA Nanocomposites by Burnishing Process

  • Author: P Murali Krishna, D. Lingaraju, N. Ramanaiah, K. Ramji

• Power Fluctuations – usage of servo voltage stabilizers in industries

  • Author: Sudha Venkatesh, Krishnaveni Muthiah